Optimization of the active-layer structure for the deep-UV AlGaN light-emitting diodes

Man Fang Huang, Tsung Hung Lu

研究成果: Article同行評審

35 引文 斯高帕斯(Scopus)

摘要

The dependence of the active-layer structure on the performance of the deep-UV AlGaN light-emitting diodes (LEDs) was theoretically investigated with an APSYS simulation program. Several structure parameters such as well width, well number, barrier height, barrier width, and doping type were employed to study how these parameters change the band structures as well as the carrier distributions. The band offset and bowing parameter used in the theoretical analysis were extracted from the experimental results. Theoretical analysis shows that the nonuniform carrier distributions as well as the low hole concentrations, which caused by polarization-induced tilted band structures, play important roles in improving the performance of the AlGaN LEDs. Compensating this asymmetric band structure and increasing the hole density are the important keys to improve the AlGaN LED performance. Numerical simulation results suggest that the higher output power can be obtained when the active layer consists of only one quantum well with a width of 1-3 nm and two thicker n-doped barriers with a small Al composition.

原文English
文章編號01658134
頁(從 - 到)820-826
頁數7
期刊IEEE Journal of Quantum Electronics
42
發行號8
DOIs
出版狀態Published - 2006 八月

All Science Journal Classification (ASJC) codes

  • Atomic and Molecular Physics, and Optics
  • Condensed Matter Physics
  • Electrical and Electronic Engineering

指紋 深入研究「Optimization of the active-layer structure for the deep-UV AlGaN light-emitting diodes」主題。共同形成了獨特的指紋。

引用此